Full Product Manual

Page 10
STEP 3: Install the Log Trays and Control Handle Lever. See FIGURE 6.
1. Remove the eight sets of M8 Bolts, and Washers from the four tabs on the beam.
2. Position the log tray frame onto the tabs as shown, and secure with the M8 hardware just removed, then tighten using
the Allen Wrench 6mm.
3. Screw the control handle lever into its linkage part on top of the valve.
REF. NO. DECSRIPTION QTY.
7
Log Tray
2
8
Hardware mounted on the tabs of beam, including:
8-1
Inner Hex head bolt / M8 x 20
8
8-2
Spring washer / M8
8
8-3
Flat washer / M8
8
9
Control Handle Lever
1
(FIGURE 6)
Page 13