Full Product Manual

Store unit in a clean, dry area. Make sure it’s switched off and unplugged.
NOTES
1. Allow the machine to cool 5 minutes after use before storing.
2. Protect power supply cable from heat, sunshine, aggressive liquids and sharp edges.
3. Do not store unit in unprotected areas outdoors. Never place near corrosive materials or in a damp environment.
4. Unscrew the control handle if you store the machine upright. Make sure it won’t tip over.
This machine can fit in most vehicles for transportation. Ensure that the splitter is properly secured before the vehicle is in
motion.
NOTES
1. NEVER move this machine while the motor is running.
2. Be extra cautious when moving this machine on rugged and rough terrain.
3. Never allow anyone to ride on the machine while transporting.
4. Make sure the vent plug is tightened during transportation.
Regular maintenance is the way to ensure the best performance and long life of your machine.
• Replace hydraulic oil every 100 hours of use. AW32 universal hydraulic oil is highly recommended.
1) Raise the wheel end of the splitter 10 in. off the
ground. See FIGURE 8
2) Place a container no less than 1.5 gallon of capacity
under the front end of the splitter.
3) Using a 19mm wrench or an adjustable wrench to
remove the oil drain bolt.
4) Disconnect the vent plug to allow the oil to drain into
the container.
5) Stand the splitter upright once the oil is drained. Refill
the reservoir tank with fresh hydraulic oil (1 gallon)
until oil level reaches the maximum line on the dipstick.
See FIGURE 5 on
Page 6.
6) Put the oil drain bolt back and tighten.
9
SECTION IV: MAINTENANCE
OFF SEASON STORAGE
TRANSPORTATION
MAINTENANCE
(FIGURE 8)