Full Product Manual

This product has been shipped pre-assembled.

• Carefully remove the log splitter and all accessories

from the box. Make sure that all components listed in

the Packing List are included. See Page 16

• Inspect the tool carefully to make sure no breakage

or damage occurred during shipping.

• DO NOT discard packing materials until you have

Carefully inspected and satisfactorily operated the tool.

• If any parts are damaged or missing, please call

1-800-780-2677 for assistance.

• Screw on the control handle lever before operation

See FIGURE 4.

NOTES:

1. If any parts are damaged or missing, do not operate this tool until the missing parts are replaced. Failure to do so

could result in possible serious personal injury.

2. Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such

alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal

injury.

• Check the oil level. See FIGURE 5

1) Remove the control handle lever and towing

handle, and then stand the log splitter upright.

2) Using a 19mm wrench or an adjustable wrench,

remove the oil drain bolt.

Wipe the dipstick and insert it all the way back into

the oil tank.

4) Take out the dipstick and see if the oil level is

between the “OK” range.

5) Add oil (AW32) if the oil level is underneath the

bottom line until the proper level is reached.

• Place the log splitter on flat, dry, solid ground.

• Block two wheels to prevent your log splitter from

moving during operation.

SECTION II: PRE-OPERATION INSTRUCTIONS

UNPACKING & ASSEMBLING

(FIGURE 4)

GETTING PREPARED

OIL

(FIGURE 5)