Replacement Part List

Page 3
STEP 2: Install the two wheels. See FIGURE 6
1. The wheel axels are attached on two wheels at the manufacturer’s. Insert the wheel axels through the axle bracket
tubes underneath the reservoir.
2. Screw the bore nuts onto the axels and tighten with an adjustable wrench. Align the holes of the nut and the axels.
3. Insert the split pin into the aligned holes axel, and then bend the ends of the pin with needle nose pliers.
REF. NO. DECSRIPTION QTY.
4
D.O.T. Tire / Wheel
2
5
Hardware Kit # 2-1, including:
1
5-1
Bored nut / M22
2
5-2
Split pin / Ø4 x 50
2
STEP 3: Install the engine / pump assembly. See FIGURE 7.
1. Insert a vibration isolator between the engine and the mount plate at each of the four mounting hole positions.
2. Secure the engine with the M8 hardware, and then tighten using two 13mm wrenches 25 ton model; or 16mm
wrench on bolts, 17mm wrench on lock nuts for 30 / 35 ton model.
(FIGURE 7)
(FIGURE 6)
8