Replacement Part List

REF. NO. DECSRIPTION QTY.
9
Engine / Pump assembly
1
10
Hardware kit # 5-1 (27 / 32T) or # 5-2 (37T), including:
1
10-1
Hex head bolt / M8 x 40 (27 / 32T) or M10 x 40 (37T)
4
10-2
Flat washer / M8 (27 / 32T) or M10 (37T)
8
10-3
Lock nut / M8 (27 / 32T) or M10 (37T)
4
10-4
Vibration isolator / Ø9 (27 / 32T) or Ø11 (37T)
4
//
O Seal ring / Ø15*1.9
2
STEP 4: Install the beam assembly. See FIGURE 8.
1. Stand the beam upright on a flat level. Two or more people are recommended to assist with raising and lowering
the beam as it is very heavy. Have a helper support the beam as you perform the following steps. Be sure to
keep hands away from any possible pinch points.
2. Remove the clevis pin and spring clip from the beam support bracket on the tank. Position the tongue / tank
assembly so that the beam support bracket is in between the two tabs on the beam.
3. Slide the clevis pin through the aligned holes and secure with the spring clip. You may need another helper to lift
up the tongue for the holes to align.
4. Leave the beam in the vertical position for continual assembling steps.
REF. NO. DECSRIPTION QTY.
11
Beam assembly
1
9
(FIGURE 8)