Replacement Part List

Page 3
STEP 5: Attach the hoses. See FIGURE 9.
1. Oil suction hose Ø24, is included in the hardware kit box, labeled as ①
Loosen the hose clamps on both ends using a flat head screwdriver, and then connect one end of the hose to the
fitting at the bottom of the pump, the other end to the bottom fitting on the reservoir. Tighten the hose clamps.
2. Pump / Valve connecting hose 1/2” labeled as ②, comes from the bottom of the valve on the beam assembly.
Screw the open end of this hose onto the fitting on top of the pump, which is also labeled as ②. Tighten using a
27mm wrench or an adjustable wrench.
3. The oil return hose 1/2” labeled as ③ comes from the top of the valve on the beam assembly
Screw the open end of this hose onto the fitting on the reservoir, which is also labeled as ③.
Make sure an O-ring
Ø15*1.9 sitting inside the fitting slot. Or you could find a spare O-ring in your hardware kit # 5-1 or 5-2
(See page 9). Tighten the hose using a 27mm wrench or an adjustable wrench.
.
10
Valve
Pump
(FIGURE 9)
Hose
Clamp