Replacement Part List

STEP 6: Install the log tray assemblies and the manual container to the beam. See FIGURE 10.
1. Lower the beam to horizontal position. Please refer to “Beam Operating Positions” section in Page 13.
2. Position the log tray frames onto the beam as shown below and secures with the M10 hardware loosely.
3. Tighten
the M10 hardware using an 16mm wrench on the bolts, and a 17mm wrench on the lock nuts.
4. Attach the manual container to the beam with the M6 hardware using a cross head screwdriver.
REF. NO. DECSRIPTION QTY.
12
Log tray assembly
2
13
Hardware Kit # 6-1, including:
1
13-1
Hex head bolt / M10 x 45
4
13-2
Flat washer / M10
8
13-3
Lock nut / M10
4
14
Manual Container
1
15
Hardware Kit # 6-2, including:
1
15-1
Phillips screw / M6 x 25
2
15-2
Flat washer / M6
2
15-3
Lock nut / M6
2
STEP 7: Assemble the control handle. See FIGURE 11 (next page).
The control handle is shipped hanging from the valve on the handle link.
1. Remove the clevis pin and bow-tie cotter pin from the valve.
2. Rotate the control handle up into the operating position and secure with the clevis pin and cotter pin just removed.
STEP 8: Engine oil and Gasoline fill-up.
Your log splitter may be shipped without engine oil. You MUST check the engine oil level before initial operating.
Refer to the engine manufacturer’s instruction manual to fill the engine oil and gasoline.
11
(FIGURE 10)