How to Guide

Figure 5
To install this unit on the wall,
follow the instructions below:
Take the assembled unit down from
the door and remove Cubby (2)
from Cabinet (1).
Unscrew Bolts (A) with Phillips
screwdriver (not included).
Figure 6
Mark 2 holes on the wall 15" apart.
The holes must be 15" apart.
Drill two 3/16" holes.
Insert Wall Anchors (C) into the two
holes, tapping lightly with hammer
(not included) as needed.
Insert Screws (B) into Wall Anchors
(C).
Tighten Screws (B) with Phillips
screwdriver (not included), leaving
1/8" between the Screws (B) and th
wall.
Page 5