Specifications

INPUT SELECTIONS
To select an input, press one of the pushbuttons labeled ONE
through SIX. The respective input will be shown in the left display and
that signal will be routed to both main outputs. For example, if input
ONE is chosen, “1. INPUT 1” will show in the left display.
Holding down any of the pushbuttons labeled ONE through SIX
for several seconds will cause no input to be selected, and “SOURCE
NONE” will show in the left display.
NOTE: There will be a slight delay when switching from one source
to another. This is necessary to allow the circuitry to adjust to the new
input source.
Select an input for recording by pressing the RECORD pushbutton,
followed by the input’s pushbutton you wish to record. An input can
be programmed not to be recordable. If you try to record an input that
has been programmed not to be recordable, the display will show ”REC
ERROR” and the input will not change.
The record output can be set to follow the main outputs. See the
programming section.
OPERATION
2-2