Specifications

VOLUME
Because the precise feel of the Boulder 2010’s volume control may be
different from what you are used to, we recommend starting the source
device so that an audio signal is fed to the 2010 before increasing the
volume.
The right display will show “VOL INFINITE” to indicate maximum
attenuation or no sound. By placing a finger on the center rotating control
and moving it slowly so it turns in a clockwise direction, the volume will
increase and an indication such as “VOL - 40.0dB” in the right display
will show the respective volume.
At this point you should be listening to music. The level of volume
step resolution may be changed–see the programming section.
WARNING: The volume control must be given the respect you would
any other volume control with its ability to get loud very quickly.
WARNING: If the input is programmed to be in “THEATER MODE,”
then the volume control will have no effect.
NOTE: The actual output level is the volume level indicated plus
the programmed input level setting. Input level is adjusted during input
programming (see pg 4-2).
OPERATION
2-3