Specifications

3-9
POLARITY
NOTE: Often polarity is mistakenly called phase. As phase indicates
any angle between two channels from 0 to 360 degrees, the correct term
of polarity is preferred to indicate the 180º phase change, or inversion,
available in the 2010 Preamplifier.
To change polarity only in one channel, start by pressing the POL
pushbutton. “POL NORMAL” will show in the right display. Then to
actually change the polarity in the desired channel, press the LEFT
or RIGHT pushbutton while “POL NORMAL” is displayed. “POL L
INVRTD” or “POL R INVRTD” will show in the right display and
the output polarity of the desired channel of the main outputs will be
inverted.
To activate a polarity change in both channels, again start by pressing
the POL pushbutton. “POL NORMAL” will show in the right display.
Now press the LEFT pushbutton and then press the RIGHT pushbutton
while “POL...” is displayed. “POL INVERTED” will show in the right
display and the output polarity of both channels of the main outputs
will be inverted.
To return to normal (noninverted) polarity, again press the POL
pushbuttons. While “POL...” is displayed, press the LEFT and RIGHT
pushbuttons until “POL NORMAL” is displayed. Both channels of the
main outputs will now be noninverted.
REMOTE
CONTROL