Specifications

“UNIT ID?”will show in the left display and “UNIT IS 16” in the
right display. This indicates the current Boulderlink address of the 2010.
The Boulderlink address can be set from 16 to 31 by rotating the center
control. For more more information, see the Boulderlink section.
Press the DISPLAY pushbutton again.
“REMOTE ID?” will show in the left display and “REMOTE IS 6”
will show in the right display. This indicates the current remote control
address. The remote control address can be set from 0 to 6 by rotating
the center control. A corresponding jumper will have to be set inside the
remote control. Contact your Boulder dealer for more information.
Press the DISPLAY pushbutton again.
“BAUD RATE?” will show in the left display and
“62500 BAUD *” will show in the right. This option selects the baud rate
at which the Boulderlink communicates. By rotating the center control,
you can select either 4800 baud or the standard 62500 baud. Unless you
have a specific reason for using 4800 baud, this option should be left at
62500 baud.
Press the DISPLAY pushbutton again to return to the programming
mode starting point.
4-6
PROGRAMMING