Specifications

OUTPUT BALANCE OFFSET
Some listening situations call for having a “permanent” output
balance offset. This could be due to inconsistent speaker sensitivity or
an asymmetrical room. The Boulder 2010’s output can be adjusted to
always be offset, even though the display shows “BAL CENTERED.”
WARNING: This programmed setup is easy to forget about. If it is
used and you find yourself wondering if the balance is off, be sure to
check this setting.
From “PROGRAM MODE” press the BALANCE pushbutton. “BAL
OFFSET?” will show in the left display, and “0.0dB” will show in the
right display. Rotate the center control until the desired output balance
is obtained as indicated in the right display. A maximum of 20.0dB may
be set.
For example, rotate the center control until “R -2.1dB” shows in the
right display. The level will be reduced in the right channel once you
leave program mode.
Then press the BALANCE pushbutton again to return to the program
mode starting point.
Press the PROGRAM pushbutton to activate the balance change and
leave program mode.
PROGRAMMING
4-7