Specifications

4-10
RECORD OUTPUTS POLARITY
The polarity of the record outputs may be adjusted to match the
recording equipment used. Consult the respective owners manual.
From “PROGRAM MODE” press the R POLARITY pushbutton. ”REC
OUT POL?” will show in the left display and “PIN 2 HIGH” will show
in the right display. Rotate the center control until the desired polarity
is shown in the right display. The polarity changes simultaneously with
the display. Then press the R POLARITY pushbutton again to return to
the program mode starting point.
To leave program mode, press the PROGRAM pushbutton.
In some installations, you may want the record outputs to follow
the main outputs during input selection. To set this feature, press the
RECORD pushbutton. The left display will show “REC = MAIN?” and
the right display will show “NO.” By rotating the center control, you
can set this to “YES.” When set to “YES” the record outputs will always
connect to the same input as the main outputs.
Press the RECORD pushbutton again to take you back to the program
mode starting point.
PROGRAMMING