Specifications

4-12
PROGRAMMING FROM THE REMOTE
CONTROL
Programming may also be conveniently done from the remote
control. Similar to programming from the front panel, all programming
is done by pressing the PGM button which causes “PROGRAM MODE”
to be displayed in the left display. You may leave program mode
whenever “PROGRAM MODE” is showing in the left display by again
pressing the PGM pushbutton.
INPUTS
From “PROGRAM MODE” press the SRC button. “NUMBER?” will
be displayed and you may press the input source number button you
wish to program from ONE through SIX. If you selected ONE, then
“1.NAME?” will shown the left display and “YES” will show in the right
display. Press the DOWN button to choose “NO” if you do not want to
name the input. Press the SRC button again to continue.
If you chose to assign a name, then “1._INPUT 1” will be displayed
in the right display with a blinking cursor in the name’s first character.
Press the UP and DOWN buttons until the desired character appears.
Again press the SRC button to accept the displayed character and go to
the next character. Continue in this manner until all 10 characters are
set.
PROGRAMMING