Specifications

4-16
“UNIT ID?” will show in the left display and “UNIT IS 16” in the
right display. This indicates the current Boulderlink address of the 2010.
The Boulderlink address can be set from 16 to 31 by pressing the UP and
DOWN pushbuttons, see the Boulderlink section.
Press the DISPLAY pushbutton again.
“REMOTE ID?” will show in the left display and “REMOTE IS 6”
will show in the right display. this indicates the current remote control
address. The remote control address can be set from 0 to 6 by pressing
the UP and DOWN pushbuttons. A corresponding jumper will have to
be set inside the remote control. contact you Boulder dealer for more
information.
Press the DISPLAY pushbutton again.
“BAUD RATE?” will show in the left display and
“62500 BAUD *” will show in the right. This option selects the baud rate
at which the Boulderlink communicates. Use the DOWN pushbutton
to select 4800 baud or the UP pushbutton to select the standard 62500
baud. Unless you have a specific reason for using 4800 baud, this option
should be left at 62500 baud.
Press the DISPLAY pushbutton again to return to the programming
mode starting point.
PROGRAMMING