Specifications

POWER UP VIA BOULDERLINK
With each component connected together with a Boulderlink cable,
and individually connected to the mains, pressing the 2010’s STANDBY
pushbutton will initiate the turn on sequence of all components.
The first time a “MASTER” 2010 is powered up, it will diplay
”SCANNING...” in the left display as it searches for any Slave units
connected to it. As the Master finds each Slave, “n ONLINE” will
displayed for that unit in the right display.
Anytime a Slave quits responding, or the Boulderlink cable becomes
disconnected, “n OFFLINE” will be displayed for that unit.
If any of the connected Slaves are amplifiers, then each time the
master is turned on it will display “WAITING FOR” ”AMPLIFIERS”.
Each amplifier will be turned on in the order of its Boulderlink ID. To
minimize turn on time, the amplifier’s Boulderlink IDs should be set
to the lowest sequential numbers possible. For example, use 0, 1, and 2
instead of 13, 14, and 15. An amplifier set to ID 15 will take 47 seconds
to turn on.
BOULDER
LINK
5-3