Specifications

6-3
PROGRAMMING FOR RECORDING
Instead of having hardware-dedicated inputs for playback (tape)
monitors, any input may be chosen for this purpose through software
selection. Connect the outputs of these recorders to any of the 6 inputs
you choose.
Then for each chosen input, follow the instructions in the
programming section for “INPUTS” until “...RECORDABLE” shows in
the left display. To prevent that input from being connected to the record
outputs (which would cause feedback) turn the center control until
“NO” shows in the right display.
This feature may be changed at any time by going through the
programming steps. You would need to do so if you wanted to dub
from one recorder to another. Make certain that only the source for the
playback device is changed to “YES” and not the recording device’s
source.
It is good practice to return that the source’s mode back to “NO”
immediately after the dubbing is finished.
The recordable option may also be changed using the remote control.
Follow the instructions in the programming from the remote control
section for “inputs” until “...RECORDABLE” shows in the left display.
Press the UP and DOWN buttons until the desired mode is reached.
RECORDING