Specifications

GETTING STARTED
INTRODUCTION
Congratulations on your selection of the Boulder 2010 Preamplifier.
We at Boulder Amplifiers are certain it will provide years of listening
pleasure.
BEFORE YOU START
To get started listening, you only need to connect the 2010 as you
would any other preamplifier and the power supply as on page 1-3, but
you should take note of the following.
WARNING: The polished volume control is attractive and because it
is optical and has no stops, it is really tempting to just spin it around. DO
THIS ONLY WITH THE POWER OFF! It must be given the respect you
would any other volume control with its ability to get loud very quickly.
By the time you have turned it up to -40.0 dB with a source turned on,
you should be hearing some music. If not, don’t proceed any louder until
you have solved the problem. See troubleshooting section.
For the 2010 to work properly, the Boulderlink’s MASTER/SLAVE
switch should be set to MASTER.
A thorough reading of this manual will definitely enhance your
enjoyment of your 2010 Preamplifier.
GETTING
STARTED
1-1