User guide

3. Suitable for sealed Central Heating systems which are within the maximum permitted working pressure. All
Boilers are supplied with a manual reset limit thermostat.
4. Suitable for new installations and for replacing existing boilers.
CAMRAY Boilers offer greater freedom to select the most suitable position for siting and the opportunity to
install the boiler in a suitable outbuilding if required.
A
ll models are supplied as standard with low level horizontal firing Oil Burner, they are suitable for connection
to a conventional chimney or any of the Camray 5/Utility Balanced Flue options. Note: The nozzle on this
appliance is only covered by a 1 year guarantee.
2:2 FLUE OPTIONS
CAMRAY Boilers are designed to operate with high efficiency, clean combustion and low noise level. They
offer unique versatility and can be used in the following modes:
1. Low level rear outlet balanced flue.
2. High level rear outlet balanced flue.
3. Vertical outlet balanced flue. (Insulated balanced draught chimney).
4. Low level side outlet balanced flue.
5. High level side outlet balanced flue.
6. For connection to a conventional chimney (via conventional Flue Kit, 40/95 Part No. FC4CF, 100/140 Part
No. FC5CF.)
7. Other options may be available. Please contact Boulter Buderus.
The tested balanced flue terminals and connections afford an adequate supply of air for combustion and
equalisation of pressure between exhaust and intake as required for operation under unfavourable wind
conditions.
Balanced flues are supplied in a carton which includes ALL parts for balanced flue installation. The horizontal
terminals are designed to avoid the possibility of staining outer walls through which they pass.
2:3 COMMISSIONING
It is essential in the interest of boiler efficiency and reliable performance that once the boiler has been
installed it is first commissioned by a qualified engineer.
If an engineer is not known, Boulter Boilers will be pleased to provide details of commissioning and servicing
engineers from their register.
See Section 7 for Commissioning Procedure.
IMPORTANT
It is the responsibility of the installer to ensure that the boiler is commissioned by a competent
engineer, preferably an OFTEC* Registered Commissioning Engineer.
*The Oil Firing Technical Association for the Petroleum Industry, Banstead, Surrey
[phone].
Pa
g
e 11 of 67
14/04/2005file://D:\PL47000\PL47000.htm