User guide

1:5.5 STARTING THE BOILER

1. Ensure that all external controls, e.g. programmer, timer, room thermostat etc., are turned on and calling for

heat.

2. Make sure the Boiler Control Thermostat is set within the recommended range (see fig 1) and that the

mains electricity and oil are turned on.

1:5.6 SWITCHING THE BOILER OFF - TEMPORARILY

The Boiler may be stopped by turning the boiler control thermostat to the OFF position on the standard

Control Panel, or the programme switch to the OFF position on the optional programmer. Alternatively, the

Boiler may be stopped by:

1. Turning off the mains switch controlling the Boiler, or

2. Turning the programmer (if fitted to the heating system) to its off position.

1:5.7 SHUTTING OFF FOR THE SUMMER

If the Boiler is to be shut off for the summer, it is advisable to have it thoroughly serviced. Thorough cleaning

will minimise corrosion during the idle period. Remember, when the Boiler is required, to ensure that the oil

supply is open before switching on.

1:5.8 SEALED SYSTEM CENTRAL HEATING

If your Camray 5 or UTlLlTY Boiler is used on a SEALED SYSTEM, it is important that the correct operating

system pressure is maintained. Your Installer should give guidance on this.

1:5.9 FROST PROTECTION

If there is any danger that your Boiler may freeze up during severe weather conditions, it is recommended that

you consult your installer who will be able to advise you on an appropriate course of action, either by installing

a frost thermostat or the addition of system anti-freeze.

1:5.10 OIL DELIVERY

Where possible, it is advisable to temporarily switch the Boiler off when your oil supply is being replenished.

This is to allow any sediment to settle and not be drawn into the Boiler. If not this could result in an

inconvenient break down.

We advise that you keep your Boiler off for one hour after the oil is delivered to your tank. Please ask your

supplier, or the driver to notify you before the oil is discharged.

1:5.11 MAINTENANCE AND TROUBLE SHOOTING GUIDE

1:5.11.1 MAINTENANCE

For normal cleaning of the outside casing, simply wipe with a dry cloth. To remove stubborn marks and stains,

wipe with a damp cloth and finish off with a dry cloth. DO NOT use abrasive cleaning materials.

The Boiler must be serviced at regular intervals by a qualified service engineer. Failure to have

BOULTER BUDERUS CAMRAY 5

PAGE 4

the Boiler serviced at the recommended intervals will invalidate the guarantee/warranty.

Using Kerosene Class C2 fuel, the Boiler should be serviced at twelve monthly intervals to ensure that the

efficiency and performance of your boiler is maintained.

e 9 of 67

14/04/2005file://D:\PL47000\PL47000.htm