TreadClimber Assembly Manual

Assembly Manual
7
Assembly
Figure 1-1
Step 1: Put the Treadles on the Base
Parts:
• TreadClimber
®
Base Assembly
• TreadClimber
®
Treadle Assembly
Hardware:
• (4) 3/8” X 1 1/4” Hex Bolts (preassembled)
Note: Hardware is only hand tightened. Finish tightening
the hardware in Step 1-5 below.
Tools:
• 9/16” Open End Wrench (included)
• Scissors or other cutting tool
• Ruler
Note: This step requires two people.
1-1 Unlock the latch lever (see Figure 1-1).
1-2 Lower the tower treadle assembly onto base with two
people.
1-3 Align roller casting flush to the base (See Figure 1-2)
1-4 Use a ruler to center the treadles between the upright
bases.
1-5 Tighten the (4) 3/8” x 1 1/4” Hex Bolts on the rear roller
casting and base with the 9/16” open end wrench (See
Figure 1-3).
Note: Tighten the outside bolts on the rear roller casting first,
then the inner bolts.
1-6 Cut the treadle zip tie located underneath the treadles.
Align roller casting so it lays flush
on base
Figure 1-2
Figure 1-3