TreadClimber Assembly Manual

Assembly Manual

Assembly

Figure 7-1

Step 7: Attach the Console/

Handlebar Assembly

Parts:

• TreadClimber

Base and Treadle assembly from Step 7

• Console/Handlebar Assembly

Hardware:

• (6) 5/16” x 1” Button Head Screws

• (6) 5/16” Flat Washers SAE

Tools:

• 3/16” Hex Key (included)

Note: This step requires two people.

7-1 Lift and position the console/handlebar assembly above

the upright supports (See Figure 7-1).

7-2 Put the console/handlebar assembly cable through the top

of the right upright support (See Figure 7-2). Make sure

that the cable extends throught the bottom of the right

upright.

7-3 Put both sides of the console/handle bar brackets into the

tops of the upright supports at the same time. Do not crimp

the cable.

7-4 Tighten the hardware with the 3/16” hex key (See Figure

7-3).

7-5 Connect the cable from the upright support to the cable on

the right side of the base upright bracket (See Figure 7-4).

Repeat this step on the other side.

7-6 One person will hold the Console/Handlebar assembly

while the second person removes the 5/16” x 1” button

head screw at the base of the support from each side.

7-7 Lower the upright on to the upright bracket base. Do not crimp

the cables. Drop the upright until flush with the base frame.

7-8 Attach the upright with (6) 5/16” x 1” button head screws

and (6) 5/16” flat washers SAE.

Note: Tighten the front (2) screws first (1 per upright) and then

the (4) side screws, two per outer side of upright (See

Figure 7-5).

Figure 7-2

Figure 7-3

Figure 7-4

Figure 7-5