TreadClimber Assembly Manual

Assembly Manual
17
Assembly
Figure 17-1
Incoming Power Plug Main Power Switch
Illustration 15-A:
TreadClimber
®
Drive and
Treadle Decals
Treadle decal
1 per side
Drive decal
1 per side
Figure 15-1
Step 15: Apply Decals
Parts:
• TreadClimber® Base and Treadle assembly from Step 14
• (2) Treadle Decals
• (2) Drive Cover Decals
Tools:
• #2 Phillips Head Screwdriver (included)
15-1 Clean the application surface with a wet cloth and dry
thoroughly with a towel.
15-2 Remove the relase backing on the decal.
15-3 Center the decal on the appropriate application surfaces
(See Figure 15-1) for locations.
15-4 Rub the decal onto the surface to force out the air bubbles.
Step 16: Inspect the Assembly
16-1 Inspect your machine to make sure that all of it has been
assembled correctly, there are no loose or missing parts
and that all of the hardware has been tightened.
Step 17: Attach the Power Cord
17-1 Make sure that the Main Power Switch is in the “Off”
postition.
17-2 Carefully insert the power cord into the Incoming Power Plug
at the rear of the base unit (See Figure 17-1).
Note: Always plug cord into the base before plugging into the
wall outlet.
Note: The TreadClimber
®
machine plugs into any standard,
grounded (three-prong) wall outlet.
NEVER remove the grounding prong from the power plug
and never use a two-prong adapter without a grounding
wire.
Failure to visually check and test assembly
before use can cause damage to the
TreadClimber
®
machine and serious injury
to users and bystanders and can also
compromise the effectiveness of your exercise
program.