Specifications

15
Operation
Starting up the projector
1. Plug the power cord into the projector and into
a wall socket. Turn on the wall socket switch (where
fitted). Check that the POWER indicator shows
steady orange light after power has been applied.
2. Remove the lens cap. If it is closed, it could
become deformed due to the heat produced by the
projection lamp.
3. Press On/Stand-By of the projector or remote
control to start the projector. The POWER indicator
light shows flash orange light to start the projector
and remain green light when the projector works.
The start up procedure takes about 30 seconds. In
the later stage of start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the
image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds before
energizing the lamp.
 To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning it off.
1.Switch all of the connected equipment on.
2.The projector will start to search for input signals. The current input signal being scanned displays in the
down right corner of the screen. If the projector doesn't detect a valid signal, the message 'No Signal' will
continue displaying until an input signal is found. You can also press SOURCE on the projector or remote
control to select your desired input signal.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the message 'Out of
Range' displayed on a blank screen. Please change to an input signal which is compatible with the projector's resolution or
set the input signal to a lower setting.