Specifications

29
WARNING
Hg - Lamp contains mercury. Manage in accordance with local disposal laws. See
www.lamprecycle.org
To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before changing the lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has
shattered into sharp pieces. Before replacing the lamp, clean the lamp compartment and dispose of cleaning materials. Be
careful of sharp edges in the lamp compartment. Wash hands after lamp replacement.
Turn the power off and disconnect the projector from the wall socket before replace the lamp. Follow with below
instruction.
CAUTION Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
1. Press MENU of remote control or unit to turn on the OSD.
2. Press to System Setup-Advance category
3. Press to Reset Lamp Timer
4. Press Enter Key to show the “confirm again” page and select OK to reset the lamp timer.
CAUTION Do not reset if the lamp is not new or replaced as this could cause damage.