Specifications

3
Important safety instructions
Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this unit near water.
6. Clean with a soft, dry cloth.
7. Do not block any ventilation openings. Install the unit in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade and the third prong are provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs. Convenience
receptacles and the point where they exit from the unit. Be sure that the power outlet is located near
the unit so that it is easily accessible.
12. use only with the stand, bracket, or table specified by the manufacturer, or sold with the unit.
13. Unplug this unit when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the unit has been
damaged in any way, such as: if the power-supply cord or plug is damaged, if liquid is spilled onto or
objects fall into the unit, if the unit is exposed to rain or moisture, or if the unit does not operate
normally or has been dropped.
15. Please read this manual before you operate your projector. Save it for future reference.
16. Do not look straight at the projector lens during operation. The intense light beam may damage your
eyes.
17. Refer servicing to qualified service personnel.
18. Always remove the lens cap when the projector lamp is on.
19. In some countries, the line voltage is NOT stable. This projector is designed to operate safely within a
mains voltage between 100 to 240 volts AC, but could fail if power cuts or surges of ±10 volts occur.
In areas where the voltage may fluctuate or cut out, it is recommended that you connect your
projector through a power stabilizer, surge protector or uninterruptible power supply (UPS).
20. Do not block the projection lens with any objects when the projector is under operation as this could
cause the objects to become heated and deformed or even cause a fire. To temporarily turn off the
lamp, press BLANK on the projector or remote control.
21. The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45