Specifications

Remote control effective range

Infra-Red (IR) remote control sensor is located on

the front and rear of the projector. The remote control

must be held at an angle within 20 degrees

perpendicular to the projector's IR remote control

sensor to function correctly. The distance between

the remote control and the sensor should not exceed

5 meters (~ 16 feet).

Make sure that there are no obstacles between the

remote control and the IR sensor on the projector

that might obstruct the infra-red

Replacing the Battery

1. Pull out the battery, Please follow the illustrated

instructions. Push and hold the locking arm while

pulling out the battery holder.

2. Insert the new battery in the holder. Note the

positive polarity should face outward.

CAUTION

Avoid excessive heat and humidity.

There may be battery damage if the battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the battery manufacturer.

Dispose of the used battery according to the battery manufacturer’s instructions.

Never throw a battery into a fire. There may be danger of an explosion.

If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to the

remote control from possible battery leakage.