Specifications

3
SECTION VIII: ELECTRICAL CONNECTIONS
This water heater must be wired to a 120volt, 60Hz or 240 volt, 50/60 Hz. power supply. Refer to the wiring diagram on
the water heater for proper field wiring connections. Refer to the water heater rating plate for the correct voltage. Refer
to the nameplate for the total amp draw for this water heater. The water heater must be wired on a separate circuit and
breaker.
If wiring in conduit is required, cut the line cord close to the control board and make the appropriate wiring connections.
FIGURE 4
WARNING
Turn off or disconnect the electrical power supply to the water heater before servicing. Label all wires prior to
disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper
operation after servicing.
All electrical wiring must be installed and grounded in accordance with local codes, or in the absence of local codes,
the National Electrical Code, ANSI/NFPA 70 and/or CSA C22.2 Electrical Code. In Canada, follow the latest edition of
the Canadian Electrical Code (Part 1, CSA-C22.1) and all applicable local codes.
CAUTION
This water heater must be wired on a separate circuit. Failure to wire on a separate circuit may cause improper
operation or failure of the electrical components of the water heater. Refer to the “Electrical Connections” section of
the Installation and Operating Instructions Manual for complete instructions on electrical wiring and connections to the
water heater.
Do not energize the electric circuit before the water heater tank is filled with water.