Submittal

ManualsBrandsBradford White ManualsCommercialBrute ® Plate Indirect Models (BLP) - Canada

page 1 of 17

Brute Plate

Commercial Indirect Water Heater

Model BLP

Submittal

Standard • ASME section VIII stamped • Completely skid-mounted and • Isolation valves

Features • Rated in accordance with wired • Temperature gauge

ANSI/AHRI Standard 400 • Double-wall stainless steel • Drain valve

• PID controller

construction • Inlet strainers

• RS 485 Modbus IP & RTU and • 3-way control valve • Compatible with condensing

BAC net IP data port • 150psi temperature & and non-condensing boilers

• Compatible with BAS/BMS pressure relief valve • 5-year heat exchanger

• Audible over-temp alarm • Backflush connections warranty

Model Data Number of Units: Model:

BLP-18D

BLP-26D

BLP-36D

BLP-52D

BLP-80D

Specifications

* Higher water flow is possible with higher than 10 psi DHW pressure drop

1024 lbs963 lbs934 lbsEstimated Shipping Weight

Water Inlet/Outlet Connection Sizes 1½" FNPT 2" FNPT

1315 lbs

BLP-80DBLP-52DBLP-36DBLP-26DBLP-18DModel

2 AmpsFull Load Amperage Draw

Standby Amperage Draw 2 Amps

120V Single Phase 60HzElectrical Requirements

Max. Boiler Water Pressure & Temp 150 psig @ 220°F

140 gpmMax. Continuous DHW Water Flow*

Ambient Temperature 32-110°F

+/- 4°FAccuracy

Adjustable Temp Control Set Point Up to 180°F

200 psigMax. Domestic Water Pressure

1082 lbs

Date:

Project #:

Engineer:

Prepared By:

Bid Date:

Project Name:

Location:

Contractor:

200 Lafayette St.

Middleville, MI 49333

Warranty: (800) 531-2111

www.BradfordWhite.com

COMMERCIAL

INDIRECT WATER

Brute

Plate

HEATER, MODEL

BLP

Submittal Data

Summary of content (20 pages)

PAGE 1
COMMERCIAL INDIRECT WATER ® Brute Plate HEATER, MODEL BLP Submittal Data Date: Project #: Brute Plate Commercial Indirect Water Heater Model BLP Submittal Standard Features Model Data Specifications • ASME section VIII stamped • Rated in accordance with ANSI/AHRI Standard 400 • PID controller • RS 485 Modbus IP & RTU and BAC net IP data port • Compatible with BAS/BMS • Audible over-temp alarm Number of Units: Engineer: Project Name: Prepared By: Location: Bid Date: Contractor: • Completely
PAGE 2
Dimensional Data Model BLP-18D BLP-26D BLP-36D BLP-52D BLP-80D "A" "B" "C" "D" "E" inches inches inches inches inches 47.5 51.8 51.5 47.8 5.8 47.5 51.8 51.5 47.8 5.8 48.6 52.5 52.8 48.4 5.8 48.6 52.5 52.8 48.4 5.8 48.6 52.5 52.8 48.4 13.6 Water Connections NPT 1½" 1½" 2" 2" 2" BRUTE-PLATE ™ CONTROL PANEL 3 WAY CONTROL VALVE PLATE & FRAME HEAT EXCHANGER 48.0 "A" "B" 3/4" NPT DRAIN VALVE BW OUT DHW IN CIRCULATION PUMP 58.1 RELIEF VALVE DRAIN 27.6 DHW OUT BW IN 11.4 "E" "D" "C" 7.6 10.2 28.
PAGE 3
Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 4
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 135 140 150 160 170 40-130 180 190 200 210 220 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 5
Performance Data, Cont.
PAGE 6
Performance Data, Cont.
PAGE 7
Performance Data, Cont.
PAGE 8
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 210 40-180 220 125 130 140 150 50-120 160 170 180 190 200 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 9
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 210 50-120 220 135 140 150 160 50-130 170 180 190 200 210 220 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 10
Performance Data, Cont.
PAGE 11
Performance Data, Cont.
PAGE 12
Performance Data, Cont.
PAGE 13
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 210 50-180 220 125 130 140 150 60-120 160 170 180 190 200 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 14
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 210 60-120 220 135 140 150 160 60-130 170 180 190 200 210 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 15
Performance Data, Cont. Domestic Water Temperature Rise °F Heat Exchanger Inlet Water Temp From Boiler °F 60-130 220 145 150 160 170 60-140 180 190 200 210 220 60-150 155 Note: Most system designers will opt to keep the pressure on the domestic water side at 10 PSIG or lower. Shaded parameters are those with higher than usual pressure.
PAGE 16
Performance Data, Cont.
PAGE 17
Performance Data, Cont.
PAGE 18
Notes: 200 Lafayette St. Middleville, MI 49333 Warranty: (800) 531-2111 www.BradfordWhite.com Litho in U.S.A.
PAGE 19
Notes: Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement. 200 Lafayette St. Middleville, MI 49333 Warranty: (800) 531-2111 www.BradfordWhite.com Litho in U.S.A.
PAGE 20
BRUTE-PLATE ™ Submittal Data Notes: Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement. 200 Lafayette St. Middleville, MI 49333 Warranty: (800) 531-2111 www.BradfordWhite.com Litho in U.S.A.