Troubleshooting guide

15
Figure 5
(c) Slide the outside wall plate over the vent terminal and fasten to the wall with 4 screws. Depending upon the
wall construction, wall anchors may be required to reinforce the screws.
(d) Install the flue cap over the outside of the angled flue discharge tube of the vent terminal. Rotate the cap so
that the vent discharge opening is in line with the angled opening of the vent terminal. The vent and air intake
openings must both be aligned to face the ground. Tighten the screw clamp so that the cap remains firmly in
place.
Figure 6
(e) Install inside wall plate on the inside wall and fasten with 4 screws. Depending upon the wall construction, wall
anchors may be required to reinforce the screws.
IMPORTANT - The flue cap must be installed over the angled flue discharge tube with the direct vent
openings facing directly down for the water heater to operate properly during rain and wind conditions.
NOTICE