Installation / Operation Instruction Manual

41
The following is the sequence of modes available in “Service Mode” by pressing the “Select” button:
Error Code Number (Display/Reset). This is only shown if there is an operating error in the “User Mode”.
1. Max Setpoint (Display/Change)
2. Water Temperature Sensor Reading.
SELECT
SET
Status
°F
idle
Water Temp
Operational

SELECT
SET
Status
idle
Operational
Max
Setpoint
°F
SELECT
Lockout RESET
Status
Service Needed
Error Code Shown in
Water Heater Display
“Max Setpoint” value
in Water Heater
Display