Installation / Operation Instruction Manual

ManualsBrandsBradford White ManualsCommercialCommander Series ® Atmospheric Vent (UCG) - Ultra Low NOx with ICON HD ® System and BMS Integration (no draft diverter models)

45

Step 3: Press the “UP” or “DOWN” buttons to change the maximum setpoint value. This will limit the maximum

setpoint the user can select. Note: The maximum setpoint is approximately 180˚F (82˚C).

Step 4: Press “Set” button to confirm new “Max Setpoint” value and stop setting mode.

Step 5: Approximately 12 minutes after the last button press, the Water Heater Display will go back to “User

Mode”. It will read “Max Setpoint” without showing a temperature value if the temperature setpoint is at the

maximum setting. The Water Heater Display can be set back to the “User Mode” immediately by pressing both the

“Temperature Up” and “Select” buttons together for 3 seconds.

"Max Setpoint" continues to flash

while making adjustments

SELECT

SET

Status

°F

idle

Operational

Max

Setpoint



SELECT

SET

Status

idle

Operational

Max

Setpoint





Exiting Service Mode

SELECT

SET

Status

°F

idle

Operational

Max

Setpoint



"Max Setpoint" stops flashing