Owner's manual

Section 4: Scion xD, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 11 of 54
8. Place DPS module under RH dash glove box area. Do not
secure with supplied 24” Wire Ties at this time. Route the
DPS wire harness up and over heater control as shown.
9. Route the DPS harness along the heater box and up to
the radio area. Use wire ties to secure harness avoiding
any moving parts.
10. Connect DPS harness to radio and connect factory radio
plug to the other end of the DPS harness. Reconnect all
connectors and antenna.
11. Reinstall radio.
12. Reconnect negative battery cable using a 10mm socket.
Re-torque battery bolt to 36 inch lbs.
13. Place DPS module with the Bongiovi DPS Acoustics side
face down. Then confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
14. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
15. Unplug the small 4-pin connector from DPS module.
16. Set Scion xD dip switches. The first, second, fourth,
and fifth switches should be flipped to the “up” position
“UUDUU”:
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the 4-
pin connector from the DPS module and wait another
10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should now
be sound from the speakers). Ensure radio head unit is
working properly including all speaker channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.