Owner's manual

Section 6: Toyota Avalon, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 16 of 54
10. Using a Plastic Trim Removal Tool, remove the dash
panel to the left of the steering wheel.
11. Remove the trim panel from around the steering
wheel and disconnect the connectors from panel.
12. Using a Plastic Trim Removal Tool, remove radio
head unit trim piece and disconnect any connectors.
13. Using a 10mm socket, remove 4 radio retaining
bolts. Remove the radio and disconnect connectors.
NOTE: For re-installation secure # 1 and #2 bolts first.
14. The DPS uses a 5 foot harness. Locate an area
under dash, console, radio, or glove box to house
the DPS module. Do not mount in an area with
moving parts or sharp edges that could cut or
damage the wire harness. Do not secure the DPS
module with the supplied 24” Wire Ties until later.
15. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
16. Reinstall radio.
17. Reconnect negative battery cable using a 10mm
socket. Re-torque battery bolt to 36 inch lbs.
18. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
19. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
20. Unplug the small 4-pin connector from DPS module.
21. Set the DPS dip switches for Avalon. The first and
fifth switches should be flipped to the “up” position –
“UDDDU”: