Owner's manual

Section 9: Toyota FJ Cruiser, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 27 of 54
12. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
14. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
15. Unplug the small 4-pin connector from DPS module.
16. Set the DPS dip switches for FJ Cruiser. The first,
second, third, and fourth switches should be flipped
to the “up” position –“UUUUD”:
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.
20. Disconnect negative battery cable.
21. Secure DPS module using supplied 24” wire ties.
Use side cutters to trim excess wire tie.
22. Re-install removed parts in reverse order of removal.
23. Reconnect negative battery cable. Re-torque battery
bolt to 36 inch lbs.
24. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.