Owner's manual

Section 10: Toyota Highlander, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 29 of 54
9. Connect the DPS harness to radio and connect
factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
10. Reinstall radio.
11. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
12. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
13. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
14. Unplug the small 4-pin connector from DPS module.
15. Set DPS dip switches for Highlander. The third
switch should be flipped to the “up” position –
“DDUDD”:
16. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
17. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
18. Turn ignition key to “LOCK” (OFF) and remove key.
19. Place DPS module behind the dash brace. Use
supplied 24” wire ties to secure to the brace as
shown. Use side cutters to trim excess.
20. Re-install removed parts in reverse order of removal.
21. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.