Owner's manual

Section 12: Toyota Prius, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 33 of 54
7. Remove the 4 screws and lift the instrument panel cup
holder assembly from the lower center instrument
cluster finish panel sub-assembly.
8. Disengage the 14 claws securing the instrument
cluster finish panel garnish. Disconnect the connector
and remove the panel.
9. Remove upper instrument finish panel by disengaging
the 3 claws, disconnecting the connector, and lifting
off the panel.
10. Remove the 4 radio retention bolts and disengage
the 4 claws. Disconnect each connector and remove
the radio with bracket,
11. Behind radio cavity, locate 2 eyelets on the heater
box and slide the two supplied 24” Wire Ties
through them.
12. Place DPS module in front of wire tie as shown, but
do not secure wire tie at this time. Route the DPS
harness along the factory harness and up to the
radio area. Secure DPS harness away from any
moving parts with supplied wire ties.
13. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.