Owner's manual

Section 13: Toyota RAV4, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 36 of 54
10. Using a Plastic Trim Removal Tool, detach the 2 clips
and 4 claws retaining the floor shift position
indicator housing and remove. Disconnect the
connector.
11. Detach the 2 clips and 2 claws retaining the console
switch base. Disconnect the connectors and remove.
12. Remove console cup holder box. Remove the 2
screws, detach the 2 clips, and remove.
13. Using a Plastic Trim Removal Tool, detach the four
clips retaining the upper rear console panel,
disconnect the connector and remove the panel.
14. Place supplied 24” Wire Tires under front console
box as shown. Do not tighten at this time.
15. Place DPS module on top of console box as shown.
Route the DPS harness along the factory harness
and up to the radio area. Secure DPS harness away
from any moving parts using supplied wire ties. Do
not tighten supplied 24” Wire Ties at this time.
16. Connect DPS harness to the radio and connect the
factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.