Owner's manual

Section 14: Toyota Sienna, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 38 of 54
1. Ensure all radio functions are working properly, return
all Treble, Bass, Fade, and Balance to neutral settings,
and remove any CDs to avoid possible jam before
disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set parking
brake.
3. Loosen negative battery cable bolt using a 10mm
socket. Remove negative battery cable from terminal
and position away from battery.
4. Remove radio. Disconnect all connectors and the
antenna.
5. Locate an area under the dash or beneath the console
to which to mount the DPS module. Do not mount in
an area with moving parts or sharp edges that could
cut or damage the wire harness. Do not secure DPS
module with the supplied 24” Wire Ties until later.
6. Connect DPS harness to the radio and connect the
factory radio plug to the other end of the DPS
harness. Reconnect all previously removed connectors
and antenna.
7. Reinstall radio.
8. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
9. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position – “DDDDD”:
10. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
11. Unplug the small 4-pin connector from DPS module.
12. Set the DPS dip switches for Sienna. The first,
second, third, and fifth switches should be flipped to
the “up” position –“UUUDU”:
13. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
14. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
15. Turn ignition key to “LOCK” (OFF) and remove key.
16. Secure DPS module using supplied 24” wire ties.
Secure DPS harness to existing vehicle wiring with
supplied shorter wire ties. Use side cutters to trim
excess.
17. Re-install removed parts in reverse order of removal.
18. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge where desired.
NOTE TO INSTALLERS: Full Sienna
instructions and photos were
unavailable at the time of this printing.
However, the basic DPS install is shared
with other Toyota vehicles covered
elsewhere in these instructions.
Please visit www.brandmotion.com for
the latest installation instructions.