Owner's manual

Section 15: Toyota Tacoma, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 41 of 54
10. Remove 4 radio retaining bolts. Disengage the 5
clips and remove radio with bracket. IMPORTANT:
Take care not to damage the clips. Disconnect all
connectors.
11. Remove right front seat bolts. Slide seat rearward
and disengage 4 claws on front trim covers then
remove 2 bolts.
12. Slide seat forward and disengage 4 claws on rear
trim covers and then remove 2 bolts.
13. Without disconnecting wires, tilt seat back and rest
seat on rear seat for support. IMPORTANT: Do not
remove wires from seat or it will be necessary to re-
calibrate occupant safety sensitivity which requires a
special programming tool.
14. Place DPS module between right seat tracks. Make a
mark on front and rear side of DPS module. Using a
utility knife, make a 1” long slit in the carpet on
either side of the DPS module. Do not secure with
supplied 24” wire ties at this time.
15. Place DPS module under seat and route harness
through factory holes in carpet up into center
console.
16. Route the DPS harness along the factory harness
and up to the radio area. Use supplied wire ties to
secure harness away from any moving parts.
29. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.