Owner's manual

Section 16: Toyota Tundra & Sequoia, 2010 – Current

2000-3811 Instructions 8-1-13.Doc Page 43 of 54

1. Ensure all radio functions are working properly,

return all Treble, Bass, Fade, and Balance to neutral

settings and, remove any CDs to avoid possible jam

before disassembly.

2. For vehicles equipped with automatic transmissions,

place shifter in the N (neutral) position and set

parking brake.

3. Loosen the negative battery cable bolt. Remove

negative battery cable from terminal and position

away from battery.

4. Lower the steering column, and move gear selector

to Low. Use a Plastic Trim Removal Tool to loosen

the upper instrument panel.

5. Pull the upper instrument panel out to provide

clearance for the HVAC panel. Do not disconnect the

upper instrument panel.

6. Use a Plastic Trim Removal Tool to unsnap the four

clips retaining the HVAC control panel and pull the

panel out. Lift slowly and carefully to avoid damage

to attached wires.

7. Disconnect all electrical connectors behind the HVAC

control panel.

8. Use a 10mm socket or Phillips head screwdriver to

remove the four 10mm hex bolts retaining the radio.

Release the three clips retaining the radio.

9. Remove radio head unit taking care not to damage

attached wires. Disconnect all connectors.

Note 1: Disassembly instructions vary according to

transmission type and seating arrangement.

Note 2: DPS module settings vary according to body

style, year, and audio system options.

Refer to instructions for full details.

FIG