Owner's manual

Section 16: Toyota Tundra & Sequoia, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 44 of 54
10. Twist shifter lever knob counterclockwise as
indicated by the arrow and remove.
11. Disengage the 12 clips retaining the console panel
and remove sub-assembly and remove.
12. Remove the rear upper console by moving shift lever
to N and disengaging the 6 claws and clip.
Disconnect the connectors and remove panel.
13. Place DPS module in console cavity. Make a mark on
front and rear side of DPS module. Using a utility
knife, make a 1” long slit in the plastic either side of
the DPS module. Do not secure with supplied 24”
wire ties at this time.
14. Route the DPS harness along the factory harness
and up to the radio area. Use supplied wire ties to
secure harness away from any moving parts.