Owner's manual

Section 16: Toyota Tundra & Sequoia, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 45 of 54
15. Connect the DPS harness to the radio and connect
the factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
16. Reinstall radio.
17. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
18. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip switches
are all set to the “down” position – “DDDDD”:
19. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
20. Unplug the small 4-pin connector from DPS module.
21. Turn ignition key to “ON” position. Turn on radio
head unit for 10 seconds. (Note: There should be no
sound from the speakers).
22. Set the DPS dip switches according to vehicle, audio
system, and/or model year:
A. 2014-present Tundra 6-speaker. The third and
fifth switches should be flipped to the “up”
position – “DDUDU”:
B. 2014-present Tundra 8-speaker. The first, third,
and fifth switches should be flipped to the “up”
position – “UDUDU”:
C. 2010-2013 Tundra 4 door. The first, second, and
fourth switches should be flipped to the “up”
position – “UUDUD”:
D. 2010-2013 Tundra Crew Cab. The third and
fourth switches should be flipped to the “up”
position – “DDUUD”: