Owner's manual

Section 16: Toyota Tundra & Sequoia, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 46 of 54
E. 2010-present Sequoia. The second, third, and
fifth switches should be flipped to the “up”
position – “DUUDU”:
23. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
24. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
25. Turn the ignition key to “LOCK” (OFF) and remove
the key.
26. Secure DPS module in console cavity using supplied
24” Wire Ties. Slide the wire ties through slits
previously made in Step 13, pull tight, and trim
excess with side cutters.
27. Re-install removed parts in reverse order of removal.
28. Re-torque seat bolts to 31 foot lbs. IMPORTANT: If
you removed any of the seat connectors, the
occupant safety settings must be recalibrated.
29. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.