Owner's manual

Section 17: Toyota Venza, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 47 of 54
1. Ensure all radio functions are working properly, return
all Treble, Bass, Fade, and Balance to neutral settings,
and remove any CDs to avoid possible jam before
disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set parking
brake.
3. Loosen negative battery cable bolt using a 10mm
socket. Remove negative battery cable from terminal
and position away from battery.
4. Remove console box carpet. Remove the 2 bolts in the
console box.
5. Remove 1 screw and 2 plastic clips. Disconnect
connectors and remove center console.
6. Twist shift lever knob counterclockwise and remove.
7. Remove screw and disengage four claws from temp
face plate and lift up and out to pull plate away.
Disconnect connectors.
8. Remove 4 radio retaining bolts, disengage the 2 clips
and disconnect the connectors and remove the radio
receiver assembly with bracket.
9. The DPS harness is 5’ long. Locate an area under the
dash or beneath the console to which to mount the
DPS module. Do not mount in an area with moving
parts or sharp edges that could cut or damage the
wire harness. Do not secure DPS module with the
supplied 24” wire ties until later.
10. Connect DPS harness to the radio and connect the
factory radio plug to the other end of the DPS
harness. Reconnect all previously removed
connectors and antenna.
11. Reinstall radio.
12. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.