Owner's manual

Section 17: Toyota Venza, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 48 of 54
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
14. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
15. Unplug the small 4-pin connector from DPS module.
16. Set the DPS dip switches for Venza. The first, third,
and fourth switches should be flipped to the “up”
position –“UDUUD”:
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.
20. Secure DPS module using supplied 24” wire ties.
Secure DPS harness to existing vehicle wiring with
supplied shorter wire ties. Use side cutters to trim
excess.
21. Re-install removed parts in reverse order of removal.
22. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.