Owner's manual

Section 19: Scion iQ, 2011 Current
2000-3811 Instructions 8-1-13.Doc Page 53 of 54
1. Ensure all radio functions are working properly,
return all Treble, Bass, Fade, and Balance to neutral
settings, and remove any CDs to avoid possible jam
before disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set
parking brake.
3. Loosen negative battery cable bolt using a 10mm
wrench. Remove negative battery cable from terminal
and position away from battery.
4. Using a plastic trim tool and your hands, remove the
V-shaped center dash panel and disconnect it from
the attached harness.
5. Use the plastic trim tool to disengage the radio cover
from the top of the dash.
6. Remove the 4 10mm bolts securing the radio and
remove the radio with bracket. Disconnect radio
connectors.
7. Locate a place to secure the DPS module under the
dash, at the front of the console, in the passenger
kick panel, or under the seat. Do not secure with
supplied wire ties at this time. Route DPS wire
harness up and over heater control.
8. Route the DPS harness along the factory harness and
up to the radio area.
9. Connect the DPS harness into the radio and connect
the factory radio plug into the other end of the DPS
harness. Reconnect all connectors and antenna.
10. Using supplied 8.5” Wire Ties, secure DPS harness
to factory harness and/or brackets taking care to
keep the harness away from any moving parts.
11. Reinstall radio.
12. Reconnect vehicle battery using a 10mm wrench
and re-torque bolt to 36 inch-lbs.
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position
“DDDDD”:
14. Turn ignition key to “ON” position making sure
radio is on. (Note: There should be no sound from
the speakers).
15. Unplug the small 4-pin connector from the DPS
module.
IMPORTANT: DPS is NOT compatible with the
optional factory BeSpoke® audio system.
shaped center dash panel and disconnect it from
ached harness.