Owner's manual

Section 2: Scion tC, 2011 – Current
2000-3811 Instructions 8-1-13.Doc Page 6 of 54
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the 4-
pin connector from the DPS module and wait another
10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should now
be sound from the speakers). Ensure radio head unit
is working properly including all speaker channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.
20. Using the supplied 24” Wire Ties, secure DPS module
to brace located in passenger kick panel. Use side
cutters to trim excess from wire ties.
21. Re-install removed parts in reverse order.
22. Use a 50/50 mix of alcohol and water to clean the
dash surface and affix the DPS badge where desired.