Installation Manual

ManualsBrandsBrandmotion ManualsCar & Vehicle ElectronicsCurb Alert Park View PRO Front Camera Parking Aid System

! INSTALLATION!INSTRUCTIONS!

5000-ca6.doc Page 1 of 5

Park View Pro with Front Camera

(Kit # 5000-CA6)

• NOTE: Do NOT discard the box as it will be used during calibration of

system at final steps. 

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Needed:

4 mounting feet

3M surface prep-pad

Allen wrench

Front sensor

Speaker with volume control

Park View Pro module

Camera with mounting foot

Chassis harness for camera

Video/power harness

3M camera mount adhesive pad

Wire strippers

Wire cutters

Electrical tape

Zip ties

Plastic panel removal tools

Digital Volt Meter / BCM safe test light

Screwdriver

Socket set

Wrench

Safety Precautions:

• Work in well ventilated area that is clear of obstructions.

• Secure vehicle with tire chucks in both front and rear of tires.

• Turn vehicle accessories OFF and ensure ignition key is in OFF position.

• Wear safety goggles and snug fitting clothes.

• Use tools only for their intended purpose and which are in good repair.

• Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color

instructions, as well as an installation video, please visit www.brandmotion.com

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Park View Pro with Front Camera (Kit # 5000-CA6) • NOTE: Do NOT discard the box as it will be used during calibration of system at final steps. Please read thoroughly before starting installation and check that kit contents are complete.
PAGE 2
INSTALLATION INSTRUCTIONS 1. Find an appropriate place to mount all components A. The Proximity sensor MUST be mounted as close as possible to the center of the front of the vehicle with a clear line of sight to the curb (it is an IR sensor and so it CANNOT be mounted behind the license plate, any panel and or object that will obstruct its view.
PAGE 3
INSTALLATION INSTRUCTIONS possibly aim sensor slightly lower then repeat step F). B. Connect the RED wire of the power harness and camera harness to an Ignition controlled power source (it is recommended to trim cable to appropriate length). C. The single BLACK wire is a negative 500ma output, that will activate for 10 seconds when the CA6 is triggered.(This can only be used to trigger a interface or monitor. Must use a relay for higher current draw or a positive output.
PAGE 4
INSTALLATION INSTRUCTIONS • 6) Use, Care and Maintenance: A. When the vehicle is turned ON you will hear a series of beeps to notify that the device is up and running B. Simply drive up to the curb at a slow speed (the device is intended for curbs that are vertical to the parking space, curbs that are at an angle will not be detected properly), and once the curb is within programmed distance the device will beep to notify you to stop. C.
PAGE 5
INSTALLATION INSTRUCTIONS Speaker and on/off switch. Front camera with foot mount. 5000-ca6.